These fine ISO VG 32 composites perform well in meeting the requirements of sleeves and rolling bearings.

Good synthetic materials can achieve high film strength with proprietary additives, so the performance of two process lubricants with the same viscosity and base oil may vary significantly. There is only one type of service that may be suitable for high reliability.

The idea that an oil type or viscosity is suitable for application is rarely true. Also, no fixed or specific oil ring geometry is ideal for oils of type and viscosity. At certain higher shaft peripheral speeds, a custom designed oil ring may be required to work with thicker oils.

With these advantages in mind, there is no reason to intrude water into the bearing boxes of process pumps and small steam turbine drives in a facility that values reliability.

When running the pump, you may reach a working temperature that allows a good flow of oil of consistency, but what if the initial working temperature at startup is low and the oil does not flow freely? This usually happens when someone buys a standard "multipurpose oil", and a good synthetic oil will be a good choice. Smart lubrication manufacturers Of course, using pure oil mist systems can circumvent these and similar problems. These systems remove a lot of human factors and are less maintenance intensive than traditional pumps and drives that use process oil lubrication and constant level process lubricators for process lubrication.