1.Overview

ZB multi-point lubrication pump is suitable for multi-line small and medium-sized mechanical equipment centralized lubrication systems with low lubrication frequency, lubrication points below 50 points, and nominal pressure of 31.5 MPa. Grease delivery oil supply device. It is especially suitable for stand-alone equipment such as metallurgy, mining, heavy machinery, and port transportation construction.

2.Technical Parameters

Applicable medium is grease with a penetration of not less than 265 (25 ° C, 150g) 1/10 mm and lubricating oil with viscosity grade greater than N68; applicable ambient temperature is -20 to + 80 ° C

3.Model Description

4.Action description

ZB multi-point lubrication pump is mainly composed of oil reservoir, reduction mechanism, oil pressure plunger pump and motor.

The motor drives the worm and worm gear to rotate at a reduced speed. The worm gear shaft drives the eccentric drive wheel to rotate at a low speed. The swash plate of the drive wheel drives the oil pressure plunger pump without the plunger to make reciprocating suction oil movement. Drain the smart lubricant outwards.

5.Dimensions

6.Essentials of use

1. This type of multi-point lubrication pump should be installed in a place where the ambient temperature is appropriate and there is less dust, which is convenient for inspection, maintenance and easy to replenish.

2. To add fat to the oil reservoir, you must use a fuel pump to add it from the fuel filler of the oil reservoir. It is strictly forbidden to cover the unfiltered medium.

3. Connect the motor according to the rotation direction specified by the rotation direction card on the wall of the oil container, and do not reverse it.

4. The number of oil supply ports can be arbitrarily selected within the range of 1 to 14. The unused oil pressure plunger pump components can be removed by themselves according to the needs of the equipment, and the screw holes can be closed with M20 × 1.5 screw plugs.

5. The adjustment of the oil supply amount can be obtained by adjusting the position of sequence 3 screw sleeve as shown in the figure below.