1.Overview

DXZ series electric oil-drying station is suitable for two-line dry oil centralized lubrication system with low lubrication frequency, piping length below 100 meters, lubrication point below 300 points and nominal pressure of 10M P a. Conveying devices are particularly suitable for heavy oil dry centralized lubrication systems in small mines without automatic control requirements.

This series of electric oil-drying station is a kind of electric oil-drying station which is directly driven by the electric motor and drives the oil pressure plunger pump element through deceleration to discharge grease. It is generally used with a dual-line oil feeder. The pressure control valve installed at the end of the system pipeline controls the reversing of the solenoid valve to realize the function of alternately supplying oil to the two main oil supply systems of the system.

2.Technical Parameters

Applicable medium is grease with a penetration of not less than 265 (25 ° C, 150g) 1 / 10mm (NLGI 0 # ~ 2 #)

3.Dimensions

4.Model Description

5.Essentials of use

1. This series of electric oil-drying stations should be installed in a place with suitable ambient temperature and less dust, which is convenient for adjustment, inspection, maintenance, disassembly, washing, and fat filling.

2. This series of electric oil-drying stations should be arranged in the center of the system as much as possible, shorten the piping length of the system and keep the pressure drop low, so that the pump can generate pressure sufficient to overcome the back pressure at the lubrication point.

3. Before use, 50 # mechanical oil must be added to the reducer to the level specified in the oil standard.

4. To replenish oil into the oil reservoir, you must use the DJB-200 electric refueling pump to add it from the oil filler of the oil reservoir. It is strictly forbidden to start the electric pump to run without intelligent grease in the oil reservoir.

5. There is a pressure gauge interface with a connection interface of Rc3 / 8 on the electromagnetic reversing valve. If it is not required, it can be blocked with a R3 / 8 screw plug.

6. The pressure regulating valve on the electromagnetic directional valve can be adjusted arbitrarily within the range of 0-10MPa, and it is not allowed to exceed the nominal pressure of the pump (10MPa) during use.

7, the first two months of dry oil station must remove the solenoid at the two ends of the solenoid valve, check the joint surface for grease leaking from the jack seal, if there is leakage, you should replace the seals in time to avoid burning the solenoid , Pay attention to check often later.

8. This series of electric oil-drying stations are installed indoors. When used outdoors or in harsh environments, protective measures must be taken.